It is very common for there to be problems with wireless connectivity. In many cases the coverage is not the best and that translates into loss of speed, stability and failures to navigate. Luckily we can make use of devices that help us to improve these aspects, although sometimes they do not work well. In this article we are going to talk about possible solutions when the Wi-Fi repeater does not work and we do not have Internet.
Wi-Fi repeater problems and how to fix them
As we say, sometimes Wi-Fi repeaters can malfunction. A bad configuration, problems with the hardware, security flaws … There are many reasons that could affect the proper functioning.
This means that we have to take steps to make it work as well as possible. We are going to show some aspects that we can take into account to have Internet and that there are no problems.
Reset the Wi-Fi repeater
In general, these types of problems usually have a simple solution. There may simply be some kind of saturation , it has been caught by continued use or some similar problem.
We can solve this type of failure simply by resetting the device . Sometimes it will be enough to restart it and at other times we will have to reset it completely to return to factory settings.
Make sure encryption is supported
Another important point is to make sure that the encryption we are using is compatible. Some devices, especially those that are older, do not support the latest ciphers.
In the event that our Wi-Fi router is using a password encryption that is not compatible with the wireless repeater, we could have problems connecting to the network. We can change to another older encryption, although we must bear in mind that this could affect our security.
Change location
This problem is very common. Many users place the Wi-Fi repeater in a dead zone . This means that it will not be able to receive a signal from the router, so it will not work properly. We connect to the repeater from another device but it doesn’t really offer internet connectivity.
We must connect the equipment in a location where it correctly receives the wireless signal. This way you can distribute it to other parts of the home without problems.
Avoid IP conflicts
Normally we can configure a static or dynamic IP address on our devices. In case we have entered an address manually it can generate problems.
You have to make sure that the IP address you have set does not match the router’s. In this way it will not create conflicts and we will be able to connect with total normality. Having control of the IP addresses in use can help us avoid these failures.
Use a suitable cable
Many Wi-Fi repeaters also allow us to connect by cable . In the event that the problem is that there is no Internet if we connect a computer by wired, the fault may be in the cable.
It is important that the wiring we use is adequate, that it is in good condition. Otherwise, we may have speed problems or we may not even be able to connect.
Switch bands
Most modern devices have dual band . We can connect to the 2.4 GHz or also to the 5 GHz. Each of them is more suitable for certain cases. The first can be better when we connect further from the device, while the second is the one that offers better speed.
It is possible that we have configured the device to work only on one band or we are connecting to the wrong one. Therefore we can choose to change bands and see if the problem is solved.
Too many connected devices
Although it is not a problem that can occur frequently, it could appear if we are using older devices . Having multiple devices running at the same time could result in the Wi-Fi repeater not working properly. We can try to turn off some and see if we solve it.