Disabling 802.11b or other old Wi-Fi modes can reduce some wireless overhead, but it does not guarantee a faster connection. Check the devices using your 2.4GHz network first: an older printer, sensor or laptop may lose access if you remove a mode it needs.

What do 802.11b and 802.11g mean?
They are older Wi-Fi standards used on the 2.4GHz band. A setting such as b/g/n mixed allows a wider range of clients than an option limited to newer standards. It does not mean that every connected device runs at the oldest standard’s maximum speed.
Wireless devices share airtime. Slow transmissions and compatibility mechanisms can use more of it, particularly in busy networks. But signal strength, interference, channel choice, the client and your internet service can also be the real bottleneck.
Check the trade-off before changing a setting
| Your situation | Reasonable choice |
|---|---|
| All clients support newer modes and coverage is good | Try the documented newer-only mode, then compare results. |
| An old printer or smart-home device needs an older mode | Keep a compatible setting or plan a separate supported network. |
| Devices already struggle at the edge of coverage | Fix coverage before raising minimum data rates. |
| Your slow device can use 5GHz or 6GHz | Test that band if supported; a 2.4GHz legacy-mode change may not be relevant. |
| The router offers no mode control | Use the options in its manual; not every router exposes this setting. |
How to check a TP-Link or other home router
- Find the exact model and hardware version. Our router identification guide shows where to look.
- Sign in to its official administration page or app. Use a wired connection if possible so a Wi-Fi change does not cut off your settings session.
- Open the 2.4GHz wireless settings and look for a documented Mode or compatibility option.
- Record the current value. Choose a newer-only option only if your devices support it, then save.
- Reconnect and test every important device. Restore the earlier value if one stops working.
Menus differ between TP-Link home routers, ASUS routers and managed access points. A model name such as ASUS BT8 does not prove a specific firmware version has a separate “disable 802.11b” switch.
Omada: rate controls are a separate setting
Omada can expose 802.11 Rate Control for a wireless network. Its current official rate-control guide describes minimum data rates, management rates and a Disable CCK Rates option for supported firmware. CCK rates of 1, 2, 5.5 and 11Mbps relate to 802.11b.
Raising minimum rates can reduce overhead in dense networks, but may also reduce discovery range or exclude clients. Follow the controller and access-point requirements in that guide rather than copying a number from someone else’s network.
How to tell whether it helped
Compare the same device in the same place before and after one change. Test a local transfer as well as an internet speed test if possible. If an older laptop no longer sees the network, use our older-laptop Wi-Fi compatibility checks. Leave beacon timing and other advanced settings at their documented defaults unless you have a clear reason to change them.
Updated October 15, 2026. Reviewed using the sources linked in this guide.